Loading...

C310 Multifunction transmitters for air and inert gases

C310 Multifunction transmitters for air and inert gases

C310 Multifunction transmitters for air and inert gases
Environment and type of fluid: Air and neutral gases
Working / storage temperature: -10 to + 50°C/-10 to +70°C
Display with simultaneous display of 1 to 3 parameters
4 visual (two-color LED) and audible alarms
2 inputs for interchangeable probes + 1 module for SPI-2 interchangeable card
Power supply 24 Vdc/Vac or 115/230 Vac
Price on request
The C310 multifunction transmitter for air and inert gas:

The C 310 transmitter is equipped with 4 independent and configurable alarms: they are visual and audible and can be associated with 3 relays (optional).

Available settings:
● Parameter selection (pressure, air speed, temperature, ...)
● Duration of delays from 0 to 600 s
● Alarm action: increasing limit, decreasing limit, monitoring or transmitter status
● Relay working mode: negative or positive safety (optional)
● Activation of the audible alarm (buzzer) which can be recognized by the front keyboard (optional)

They can be connected in a network that works on an RS485 home bus (OPTIONAL). RS 485 digital communication is a 2-wire network, on which the transmitters are connected in parallel.They are connected to a PLC / BMS via the Modbus RTU communication system.Since C310 can be configured with the keyboard, the system enables remote configuration to measure 1 or 2 parameters or to check the status of the alarms.

An Ethernet card can be installed on a C310 transmitter (OPTIONAL) thus allowing each transmitter to have a specific configurable IP address. The user can therefore interrogate the transmitter remotely, retrieve the data, modify the configuration.It is also possible to integrate the C310 transmitters into a computer network via the RJ45 connection located on the bottom of the transmitter.

The class 310 transmitters allow you to set all the parameters managed by the transmitter: units, measurement range, alarms, outputs, channels ... using the different methods shown below:
➢ By keyboard: only models with display. A protection system, with keypad code, ensures installation safety. See the configuration manual.
➢ Via the software (optional): simple and easy to use. See the LCC-S user manual.
➢ Via Modbus (optional): configuration of all parameters from your PC, via the supervision or data acquisition software.
➢ Via Ethernet (optional): configuration of all parameters from your PC, via the supervision or data acquisition software.

    Technical Characteristics

    Description:
      • Multifunction transmitter for air and inert gas
      Dimensions:
        • 136x158x81 mm
        Materials not in contact with the fluid:
          • ABS V0
          Degree of protection:
            • IP65
            Operating temperature:
              • 0÷+50 [°C]
              Weight:
                • 700 g
                Display:
                  • Graphic display from 1 to 4 lines, 240 x 128 px; Dimensions: 86 x 51 mm, backlit
                  Outputs available:
                    • 2 x 0/4-20 mA a 2 x 0-5/10 V (4 fili)
                      4 x 0/4-20 mA
                      4 x 0-5/10 V (optional)
                      Maximum load: 500 Ohms (0/4-20 mA) / Minimum load: 1 K Ohms (0-5/10 V)
                    Electrical connection:
                      • Terminal block for cables from 0.05 to 2.5 mm2 or from 30 to 14 AWG
                      Approvals:
                        • EC Declaration of Conformity