FP-3011 Flow and thermal energy calculator

• Ability to measure, display and record additional values not related to settlement systems (eg condensate level in the tank)

• Algorithm of overshooting of the ordered power and of the excess energy meter with the possibility of registration saturation of superheated steam

• Advanced user and password system

• 1 optional 4-20mA analog outputs

• Available also in wall-mounted case – FP-3011N

Measurement and additional calculations

• 8 additional channels: measurement of additional quantities or calculations

• Additional quantities are omitted when performing calculations related to the flow measurement system

• Calculated quantities may serve as auxiliary values or be used directly in measurement systems

The device has ten measurement inputs

2 x RTD/I, two inputs adapted for connection of resistance temperature sensors (Pt100, Pt200, Pt500, Pt1000, Ni100, Ni1000) and transducers with a 0/4‑20mA current output

1 x I, one input for interaction with 0/4‑20mA transducers only

2 x I/PULS, two inputs intended for connection of transducers with a 0/4‑20mA current output or with a pulse output (range 0.001Hz … 10kHz)

RTD type analog inputs

Sensor type: Pt-100 x K, Ni-100 x K (K = 1 .. 11) K – multiplier, ex: for Pt-200 K = 2
Measuring range: -200 .. +850 °C for Pt100 x K-60 .. +150 °C for Ni100 x K
Sensor connection: 2 or 4 wires
Wire resistance compensation: Manual, in the range -99.99 .. +99.99 ꭥ
Maximum resistance of the connecting wires: 50 ohms
Resolution of the A/D converter: 18 bit
Thermal drift: Maximum ± 0.02°C/°C
Galvanic isolation between inputs: No, common potential GND for all inputs
Galvanic isolation from supply voltage: 400 VAC (functional isolation)

0/4-20mA type analog inputs

Signal type: 0-20mA or 4-20mA
Transmitter connection: Passive (powered by the measuring point) or active converter
Input resistance: 100W±10%
Transmitter supply: 24 Vdc / maximum 22 mA
Resolution of the A/D converter: 18 bit
Thermal drift: Maximum ±50 ppm/°C
Galvanic isolation between inputs: No, common potential GND for all inputs
Galvanic isolation from supply voltage: 400 VAC (functional isolation)

PULS type inputs (binary/pulse/frequency)

Maximum input voltage: ±28 VDC
Galvanic isolation between inputs: No, common potential GND for all inputs
Galvanic isolation from supply voltage: 400 VAC (functional isolation)
Functions: Status Detection/Pulse Counting/Frequency Measurement
Measuring range: 0.001 Hz .. 10 kHz (0.001 Hz .. 1 kHz with filter capacitor)
Minimum pulse width: 20 ms

Panel version FP-3011

Dimensions (width x height x depth): 144mm x 72mm x 130mm

Frame depth with end caps: approx. 140mm

Wall case version FP-3011N

Dimensions (width x height x depth):

257 mm X 217 mm X 125 mm (without cable glands)

257mm X 247mm X 125mm (with cable glands)